SystemiSOX Building Boards
Extremely strong building boards with technically superior coating for 100% waterproofness!
ApplicationSurface levelling
Tip!
- In dry areas the seams should be reinforced with joint reinforcement tape and M 20.
- On even substrates building boards can be laid by bonding throughout.
- For bonding with dowels, in case of uneven substates, the boards of minimum thickness of 20mm must be used.
- M200 can be used to glue the panels on the wall. This fast drying material can also be used to fill holes or slots in the wall.
Products needed
ApplicationCreating a shower partition
Tip!
- Building boards of a minimum thickness of 20mm should be used. The building boards are screwed to the stud frame.
- For the composite waterproofing in wetrooms use the flexible, single component sealant slurry Botament® MD 1 Speed together with a Sealing tape. Thicknesses that fall below 20 mm must be fastened additionally (dowels, bolts).
Products needed
ApplicationConcealed system for WC tank isox-consealed-toilet isox-inbouw-toilet
Tip!
- You can create claddings for virtually all wallmounted WC’s types and sizes.
- Apply reinforcement tape at joints and edges using Botament® M 20 Classic .
Products needed
ApplicationPipe cladding
Tip!
- Determine the length you need the cladding to be and cut to size.
- Apply Botament® M 20 Classic in pyramid-form to both sides of the pipe cladding. Press the cladding against the walls to fix it to the walls.
- Use a spirit level to make sure both sides are level. Remove any excess adhesive.
- The pipe cladding can be tiled straight away. There is no need for prior priming.
Products needed
ApplicationFloor level tiling (mineral substrates)
Tip!
- If necessary, treat the surface with Deep Action Primer Botament® D11.
- Use boards of a minimum thickness of 10 mm which should be laid staggered.
- iSOX building boards form a secure, waterproof barrier and provide an excellent bonding surface for tiling. Superior thermal insulating properties make iSOX building boards particularly suited in combination with underfloor heating.
- For the composite waterproofing in wetrooms use the flexible, single component sealant slurry Botament® MD 1 Speed together with a Sealing tape.
Products needed
ApplicationBuilding shelves and recesses
Tip!
- You can use two L elements or one U element when making shelves.
- Additional supporting structure might be needed for shelves for heavier loads.
- Waterproofing with the flexible single component sealant slurry 1K Botament® MD 1 Speed and a sealant tape.
- Apply reinforcement tape at joints and edges using Botament® M 20 Classic.
Products needed
ApplicationRaised platforms and round shapes
Tip!
- A minimum thickness of 30mm should be used for the platform structure, with the maximum distance between construction struts at 30cm.
- Joints on the platform must always be underpinned with the construction struts.
- In dry areas the seams should be reinforced with joint reinforcement tape and Botament® M 20Classic.
Products needed
ApplicationCladding baths
Tip!
- No additional re-enforcing is needed for the cladding.
- Use Flex-Board to create round-shaped claddings.
- Apply iSOX Polymer to seal along the top edges of the boards.
